10.10.19. Removal, installation and adjustment of a sound signal

The sound signal is in a motor compartment and fastens arms to facing of a radiator.
It will be required to you: a key "on 10", the screw-driver with a flat edge.
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Disconnect blocks with wires from signal conclusions.
3. Turn out two bolts of fastening of an adjusting arm of a signal to facing of a radiator …
4. … also remove a sound signal together with arms.
5. If necessary turn off a nut of fastening and remove arms from the signal case.
6. Smooth out the oxidized signal conclusions.
7. Clamp in a vice a signal for an arm and connect wires to the rechargeable battery and conclusions of a sound signal ("minus" to the top conclusion of a signal, "plus" to the lower conclusion of a signal).
8. Turning the adjusting screw in the relevant party, achieve loud and pure sounding of a signal. If it was not succeeded to make it, replace a sound signal.
9. Establish a sound signal and all removed details in the sequence, the return to removal.