10.13.1. Removal, repair and installation of glass cleaner of a door of a back

It will be required to you: screw-drivers with flat and crosswise edges, keys "on 10", "on 24".
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Mark a cleaner brush arrangement on glass.
3. Turn a decorative cap …
4. … turn off a nut of fastening of a screen wiper …
5. … remove it together with a washer …
6. … also remove the brush lever from the screen wiper mechanism roller.
7. Remove a protective cap …
8. … turn off a nut of the top fastening of a screen wiper …
9. … remove metal …
10. … and rubber the leveling washers.
11. Remove a back door upholstery (see. "Removal and installation of an upholstery of a door of a back").
12. Separate a block of a plait of wires of the electric motor of a screen wiper …
13. … turn out two bolts of fastening …
14. … also remove a screen wiper from a back door.
15. Remove a rubber sealing ring and a metal washer from the reducer case.
16. Remove a lock ring from the screen wiper mechanism roller.
17. Remove a washer.
18. Take out a sealing ring from a pro-point.
19. Unscrew four screws of fastening of a cover of a reducer.
20. Uncover with an arm.
21. Accurately remove sealing laying.
22. Take out from the case of a reducer drove.
23. Remove a reducer gear wheel, having raised it the screw-driver.
24. Unscrew two screws (the second screw is behind the reducer case).
25. Take out two mortgage nuts.
26. Remove the engine case.
27. Take out an anchor from a cover and the case.
28. Replace the springs of brushes broken or lost elasticity. Check ease of movement of brushes in the brush holder: they have to move freely, without jammings. Replace the worn-out or having chips of a brush. When replacing solder conclusions of new brushes to the brush holder.
29. Smooth out a small skin of the collector if he is polluted or on him risks, scratches and other damages are found. If the collector is strongly worn-out or burned, replace an anchor or a reducer with the electric motor assembled. At detection of traces of jamming on necks of an anchor smooth out necks a fine-grained skin.
30. Replace a reducer gear wheel with strongly worn out or damaged teeths. Examine contacts of the trailer switch of the mechanism of a self-stop. Smooth out the oxidized contacts. If contacts are broken, replace a gear wheel.
31. At damage of shliyets or carvings of rollers and at breakage of teeths replace drove.
32. Replace the rubber pillows and other rubber details torn, cracked or lost elasticity. Before replacement of pillows take out the expansion plug.
33. Collect and establish a screen wiper upside-down. At assembly of a reducer grease with jellied lubricant a reducer gear wheel, a worm of a shaft of the electric motor, drove the roller and teeths.