10.6.2. Removal, installation and dismantling of the switch (lock) of ignition
It will be required to you: the hammer, a chisel, the screw-driver with a flat edge.
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Remove a casing of a steering column (see. "Removal and installation of a casing of a steering column").
|
|
3. Disconnect a block with ignition switch wires from a plait of wires of the dashboard.
|
4. Turn out by means of a chisel and the hammer …
|
|
|
5. … or drill two bolts with samosrezny heads (for convenience of photographing these operations are shown on the removed helmsman to a shaft) …
|
6. … also remove the switch from a steering column.
|
Note
So the switch (lock) of ignition removed from the car looks.
|
|
|
7. It is possible to carry out dismantling and an inspection of contacts of the switch of ignition, without removing it from the car. Turn out the fastening screw …
|
8. … drown the fixing pin the screw-driver …
|
|
|
9. … take the ignition lock from the case …
|
10. … turn out two screws of fastening of contact group to the ignition lock …
|
11 … also disconnect contact group from the lock.
12. Examine contacts of the lock. Smooth out the oxidized or burned slightly contacts a fine-grained grinding skin. At strong damage of contacts replace contact group or the lock assembled.
13. Collect and install the ignition switch as it should be, the return to removal.