4.3.1. Replacement of oil in the engine and an oil filter

It will be required to you: a key "on 24", a key for removal of an oil filter, a funnel, a pure rag.

Useful tips
Merge oil after a trip until the engine cooled down. If the engine cold, launch and warm up it up to the working temperature.
Fill in oil of the same brand that was in the engine. If all of you decided to replace oil brand, wash out the lubrication system flushing oil or oil of that brand which will be used. For this purpose after discharge of old oil fill in new to the lower tag of the index of level of oil. Launch the engine and let's it work 10 min. idling. Merge oil and only after that replace an oil filter. Now you can fill in new oil to the required level (to the top tag on the probe).
For an otvorachivaniye of an oil filter use a special key. If there is no such key or a similar stripper, punch the filter case the screw-driver and, using it as the lever, unscrew the filter, and punch the filter as it is possible closer to a bottom not to damage the union. It is also possible to use the strip of a rough emery paper curtailed twice, having wrapped up it the filter and having shifted it from the place hands.

Prevention
Do not merge the fulfilled oil on the earth.

1. Remove the generator (see. "Removal and installation of the generator on cars with the petrol engine").
2. Establish under an engine case capacity for the fulfilled oil. Turn out a stopper and merge oil from a case. Wrap a drain stopper.
3. On engines of family 409 the filter 2101C-1012005-HK-2 (either 2108-1117010-03, or 4021.1117010) installed below on the block of cylinders on the right side is used.
4. For its replacement unscrew the old filter hands …
5. … or special adaptation also wrap the new filter.

Prevention
It is necessary to wrap the filter only manually, without use of any tool, previously having oiled its laying by fresh engine.

6. Fill in fresh oil to the tag "П" on the index of level of oil.