4.4.12. Adjustment of the drive of the parking brake

Lift the lever of the parking brake up to an emphasis, at the same time 3–5 clicks of the ratchet device have to be heard. If the number of clicks does not keep within the set limits, so between blocks and the brake drum of the parking brake system big gaps were formed or the cable of the drive of the parking brake was extended.
For adjustment of gaps between blocks and the brake drum you will need a key "on 11".
1. Lower the lever of the parking brake in extreme lower situation.
2. Wrap the screw of adjustment of provision of blocks so that the brake drum was not turned by effort of hands.
3. Turn out the adjusting screw on 1/3–1/2 turns to a free provorachivaniye of a drum.
The tension of a cable of the drive is regulated by change of length of draft of the drive of the parking brake.
It will be required to you: a key "on 10", the screw-driver with a flat edge.
1. Uncover the floor hatch (see. "Removal and installation of covers of the hatch of a floor").
2. Weaken an inhaling of a kontryashchy nut of a fork of draft …
3. … to a rasshplintuyta an axis of draft and, rotating it, choose a gap in the razzhimny mechanism and the drive.
4. Tighten a kontryashchy nut, a zashplintuyta an axis of draft and check the number of clicks of the ratchet device of the lever of the parking brake.
5. If the number of clicks corresponds to the required value, establish all earlier removed details as it should be, the return to removal. Otherwise repeatedly adjust draft length.