5.13.4. Replacement of epiploons of a bent shaft

Sign of need of replacement of a forward epiploon of a bent shaft is leak of oil through its edge. At the same time oil is sprayed by the rotating pulley of a bent shaft owing to what greasy are all forward parts of the engine and a motor compartment.
Sign of need of replacement of a back epiploon of a bent shaft is leak of oil through its edge. Oil is sprayed by the rotating flywheel in a case of coupling and then follows outside through cracks between a case and its amplifier. At a strong leak oiling of overlays of the conducted clutch plate and, as a result, coupling pro-slipping is possible.
And leak of oil from a case of coupling can be the reason of oiling of clutch plates to flow an epiploon of a main shaft of the transmission.
Motor and transmission oils have a different smell therefore at a certain skill it is possible to determine by a smell, defective, what of epiploons.

Useful tips
There is one more way of definition like oil. Drip oil in the water poured in a vessel by a thin layer (it is possible in a pool). Gearbox oil will spread on all water surface in the form of an iridescent film, and engine oil will remain in the form of the drop similar to lentil grain.
Before replacing a forward epiploon of a bent shaft at emergence of a leak, check purity of system of ventilation of a case of the engine as in case of its contamination the elevated pressure of gases in a case causes to flow even at a serviceable epiploon.

It will be required to you: a key "on 36", a face head "on 17" (or a special key for a nut of fastening of a pulley of a bent shaft), the screw-driver, an assembly shovel (two), the hammer, small beards.
For replacement of a forward epiploon of a bent shaft execute the following operations.
1. Take off a belt of the drive of the pump of the hydraulic booster of steering and a pulley of the fan from a pulley of a bent shaft (see. "Replacement of a belt of the drive of the pump of the hydraulic booster of steering and pulley of the fan of the cooling system").
2. Take off a generator drive belt (see. "Replacement of a belt of the drive of the generator").
3. Turn out six bolts of fastening of a pulley of a bent shaft...
4. … also remove a pulley from a nave.
5. Turn out a bolt of fastening of a nave of a pulley of a bent shaft and press it assembly shovels.

Good advice
To record a bent shaft from a provorachivaniye, include the V transfer and slow down the car the parking brake.

Note
Sometimes the pulley напрессован hardly and is not possible to remove it assembly shovels. In this case it is necessary to use a universal stripper.

6. Having hooked the screw-driver, take an epiploon.
7. Fill with Litol-24 lubricant a cavity of a new epiploon between a working edge and a boot and press an epiploon in a forward cover a working edge inside, using an old cuff as a mandrel.
8. Establish into place a belt of the drive of the generator and adjust its tension (see. "Replacement of a belt of the drive of the generator and water pump").

For replacement of a back epiploon of a bent shaft execute the following operations.
1. Remove the transmission (see. "Removal and installation of the transmission").
2. Remove coupling (see. "Removal and installation of coupling").
4. Having hooked the screw-driver, take an epiploon.
5. Fill a cavity of a new epiploon between a working edge and a boot Litol-24 lubricant and press an epiploon in a forward cover a working edge inside, using an old cuff as a mandrel.

Note
Establishing an epiploon, accurately fill a working edge of an epiploon on a neck of a bent shaft.

6. A mandrel of suitable diameter press an epiploon against the stop.
7. Establish the removed knots as it should be, the return to removal.