5.13.5. Replacement of consolidation of an oil case

If leak of oil through laying of an oil case does not manage to be eliminated with tightening of bolts of its fastening, so laying is strongly deformed and it needs to be replaced.

Note
Perform work on the elevator or a viewing ditch.

It will be required to you: keys (face heads) "on 12", "on 14", "on 17", the extender, cardan hinges.
1. Remove an engine mudguard (see. "Removal and installation of mudguards of the engine").
2. Merge oil (see. "Replacement of oil and oil filter").
3. Turn off nuts of two bolts of fastening of a case of coupling to the amplifier and take out bolts.
4. Turn out two bolts of fastening of the amplifier of a case of coupling to the block of cylinders on both sides …
5. … also remove the amplifier of a case of coupling.
6. Turn off a nut of a drain hose of the oil heater and disconnect a hose from the union of an oil case.
7. Turn off eleven bolts and four nuts of fastening of an oil case to the block of cylinders and remove an oil case of the engine.
8. Remove laying from hairpins of the block of cylinders.
9. Before installation of new laying degrease privalochny surfaces of an oil case and the block of cylinders, and then establish laying into place.
10. Establish an oil case and tighten evenly bolts and nuts of its fastening to the block of cylinders the moment specified in the appendix 1.
11. Establish the removed details as it should be, the return to removal.
12. Fill in oil in the engine (see. "Replacement of oil in the engine and an oil filter").

In such sequence it is necessary to tighten bolts of fastening of an oil case of the engine