5.18.2. Removal and installation of a radiator
It will be required to you: keys "on 10", "on 14", the screw-driver with flat and crosswise edges.
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Merge liquid from the cooling system (see. "Replacement of cooling liquid").
|
|
3. Turn out two screws from above …
|
4. … two screws from below …
|
5. … also remove an extension of a guard of facing of a radiator. Similarly remove the right extension of a guard of facing of a radiator.
6. Turn out four bolts of fastening of the oil heater and take him aside.
|
|
7. Disconnect wires from the sensor of an alarm lamp of an overheat of cooling liquid.
|
8. Weaken an inhaling of a collar of fastening of a steam discharge hose …
|
|
|
9. … also remove a hose.
|
10. Weaken an inhaling of a collar of fastening of the bringing radiator hose …
|
|
|
11. … remove a hose from a radiator branch pipe.
|
12. Weaken a collar of fastening of the taking-away radiator hose.
|
13. Turn out four bolts of fastening of a casing of the fan and take away a casing.
14. Turn out bolts on both sides of drafts of fastening of a radiator.
Note
From below the radiator fastens to frame arms bolts through rubber pillows.
|
|
|
15. Remove the fixing wire …
|
16. … also turn out a bolt. Similarly turn out the second bolt.
|
17. Take out a radiator from a motor compartment.
18. Wash out a radiator outside a stream of water and dry. If on a radiator there are cracks, replace it.
19. Check tightness of a radiator for what muffle radiator branch pipes, except one to which bring a hose for supply of compressed air. Lower a radiator in a bathtub with water and give air under pressure of 1 atm approximately on 30 pages. In the damaged places there will be air bubbles. In this case replace a radiator.
20. Examine pillows of fastening of a radiator. If they are torn, cracked or rubber lost elasticity, replace pillows.
21. Establish a radiator as it should be, the return to removal.