5.18.5. Removal and installation of the water pump

Remove the water pump for access to other details, for repair or replacement at emergence during its work of noise which level exceeds usual and which appears at formation of a big radial side play of a shaft of the pump.
Dismantling of the pump — quite laborious work therefore at malfunction replace the pump assembled.
It will be required to you: a key "on 12", a hexagon "on 6", the screw-driver with a flat edge, an assembly shovel.
1. Merge liquid from the engine cooling system (see. "Replacement of cooling liquid").
2. Remove a radiator (see. "Removal and installation of a radiator").
3. Take off a belt of the drive of the pump of the hydraulic booster and a pulley of the fan (see. "Replacement of a belt of the drive of the pump of the hydraulic booster of steering and pulley of the fan of the cooling system").
4. Remove the viscous coupling of the drive of the fan (see. "Removal and installation of the viscous coupling").
5. Take off a belt of the drive of the generator and water pump (see. "Replacement of a belt of the drive of the generator").
6. Holding with an assembly shovel a pulley from a provorachivaniye, turn out three bolts …
7. … remove a pulley reflector …
8. … and pulley.
9. Turn out two top bolts …
10. … and one lower bolt of fastening of an arm of the pump of the hydraulic booster …
11. … then take an arm assembled with the pump of a gudrousilitel aside.
12. Weaken an inhaling of fastening of a collar of a hose of the thermostat …
13. … and water intake tube hose.
14. Turn out two forward bolts …
15. … and one bolt from the back party …
16. … then remove the water pump.
17. Clear a privalochny surface of old laying.
18. Install the water pump and all removed details upside-down, apply sealant on the interfaced surfaces of the water pump and the block of cylinders.
19. Fill in cooling liquid and remove air traffic jams from the cooling system (see. "Replacement of cooling liquid").