5.20.8. Replacement of a cable of the drive of a butterfly valve
If the butterfly valve not completely opens (the engine does not give full capacity) or is not completely closed (idling turns are unstable), at first try to adjust a cable of the drive of a butterfly valve. If adjustment of the drive of a butterfly valve it is impossible to achieve full opening or closing of a butterfly valve or the drive jams, replace a drive cable.
It will be required to you: two keys "on 13", screw-drivers with flat and crosswise edges.
|
|
1. Take out a cable tip from a sector groove …
|
2. … also disconnect a cable from throttle knot.
|
|
|
3. Weaken nuts of fastening of a cover of a cable to an arm...
|
4.... also bring a cable out of an arm cut.
|
5. Take out a cable from a clamp on the engine.
6. Take out the forelock from a pedal of an accelerator and remove from it a cable tip.
7. Shift a cable cover forward and take a cable in a motor compartment.
8. Establish a cable as it should be, the return to removal.
9. Adjust the drive of a butterfly valve (see. "Adjustment of a cable of the drive of a butterfly valve").