5.7. Replacement of a belt of the drive of the generator and water pump
It will be required to you: keys "on 10", "on 12".
1. Take off a belt of the drive of the pump of the hydraulic booster of steering, a pulley of the viscous coupling and a pulley of a bent shaft (see. "Replacement of a belt of the drive of the pump of the hydraulic booster of steering and pulley of the fan of the cooling system").
|
|
2. Weaken an inhaling of a bolt of fastening of a tension roller on two-three turns.
|
3. Turning out an adjusting bolt, weaken a tension of a belt and remove it.
|
4. Establish a new belt; rolling an adjusting bolt of a tension roller, achieve a deflection of a belt of 15 mm under the load of 80 N (8 kgfs) enclosed in the middle belt branches between the generator and the water pump.
Good advice
The tension can be controlled, delaying a belt branch spring scales like steelyard.
|
5. Tighten a bolt of fastening of a tension roller.