6.3.3. Removal and installation of the transfer case

It will be required to you: keys "on 10", "on 12", "on 17", the screw-driver with a flat edge.
1. Install the car on a viewing ditch or the elevator.
2. Merge oil from the transfer case (see. "Replacement of oil in the transfer case").
3. Remove driveshafts (see. "Removal and installation of cardan transfer").
4. Remove a decorative cover of a control lever the transmission together with a forward rug of a floor.
5. Turn out three screws …
6. … also remove a protective cover of a control lever the transfer case.
7. Turn out a coupling bolt of klemmovy fastening of a control lever the transfer case …
8. … unclench the screw-driver with a flat edge klemmovy connection …
9. … also remove the lever.
10. Similarly remove a control lever the transmission.
12. Disconnect a block of a plait of wires from the speed sensor.
13. Turn out two bolts of fastening of the transfer case to the transmission on the left side …
14. … one bolt on the right side from above …
15. … one bolt from below …
16. … also remove the transfer case assembled with the mechanism of the parking brake.
17. Install the transfer case as it should be, the return to removal.

Note
Before installation of the transfer case apply sealant on privalochny (to the transmission) the surface of the transfer case.