6.5.3. Replacement of an epiploon of a shaft of the leading gear wheel of a reducer of the forward bridge

Replace an epiploon at detection of leak of oil from under a reducer flange.

Note
The leak of oil can be caused also by excess of oil in a case or a contamination of a sapun.

It will be required to you: a face head "on 27", a neck, the screw-driver with a flat edge, a dynamometer key.
1. Slow down the car the parking brake, establish an emphasis under back wheels of the car. Lift and establish a forward part of the car on support.
2. Holding bolts from a provorachivaniye, turn off four nuts of fastening of the driveshaft to a flange of a reducer of the forward bridge, take out bolts and take a shaft aside (see. "Removal and installation of cardan transfer").
3. Turn off a nut of fastening of a flange of a shaft of the drive of the forward bridge.
4. Remove a flange with a reflector.
5. Having hooked the screw-driver, take an epiploon from a bridge case.
6. A mandrel of the suitable size press a new epiploon into place.

Note
As a mandrel it is possible to use an old epiploon.

7. Establish details as it should be, the return to removal.
8. Tighten a nut of a flange of a shaft of the leading gear wheel of the forward bridge, turning a shaft for a flange that bearings rose on the place (see. "Adjustment of gpodshipnik of the main transfer of the forward bridge").