6.6.8. Removal and installation of the back bridge

Zadny Bridge is removed at wear-out of all details when partial repair becomes inexpedient, or for replacement of its beam.
It will be required to you: keys "on 17", "on 19", a face head "on 17".
1. Install the car on a viewing ditch or the elevator.
2. Weaken an inhaling of nuts of fastening of back wheels.
3. Turn off a nut of a bolt of fastening of a rack of the lever of the regulator of pressure of brake forces, lift and fix the lever in the top situation in order to avoid leak of brake fluid at a detachment of a brake hose from a pipeline tee.
4. Disconnect a brake hose from a tee of the pipeline located on the back bridge.
5. Disconnect the back driveshaft from a flange of the back bridge and take the driveshaft aside (see. "Removal and installation of cardan transfer").
6. Turn off nuts of bolts of the lower fastenings of both back shock-absorbers and take bolts.
7. Turn off four nuts of step-ladders on both sides of fastening of the back bridge to a spring.
8. Lift a back part of the car and roll out from under it the back bridge.
9. Turn off nuts of fastening of wheels and remove wheels.
10. Establish the back bridge as it should be, the return to removal. After installation remove air from a back contour of the brake system (see. "Pumping of a hydraulic actuator of the brake system").