7.1.12. Replacement of details of the stabilizer of cross stability of a forward suspension bracket

Removal of the stabilizer of cross stability is necessary at damage of its bars. For replacement of plugs it is enough to disconnect one of fastenings of the stabilizer.
It will be required to you: keys "on 17", "on 19", an assembly shovel.
1. Install the car on a viewing ditch or lift and establish a forward part of the car on support.
2. Turn off two nuts of step-ladders of fastening of the stabilizer of cross stability …
3. … also remove a step-ladder and its slip.
4. Wring out an assembly shovel a stabilizer bar …
5. … remove a pillow holder …
6. … and pillow.
7. Similarly remove the second pillow.
8. Turn out two bolts of fastening of a holder of a pillow of fastening of the stabilizer to a car frame.
9. Remove a holder …
10. … and cutting pillow of fastening of the stabilizer of cross stability.
11. Similarly remove the second pillow of fastening of the stabilizer.

Note
On pillows cracks, gaps and hardenings of rubber, and also mechanical damages and wear of the internal surfaces contacting to a stabilizer bar are not allowed. Replace defective pillows.

Good advice
For simplification of installation of new pillows on a bar of the stabilizer grease a bar with saturated soap solution.

12. Remove a bar of the stabilizer of cross stability and examine it. Replace the bar deformed or having cracks.
13. Establish details of the stabilizer of cross stability as it should be, the return to removal.