7.1.3. Removal and installation of a nave of a forward wheel

It will be required to you: a key "on 14", a special tubular key "on 55", a neck, the screw-driver with a flat edge, the hammer, a chisel, an assembly shovel.

Good advice
The nave of a forward wheel can be removed assembled with a brake disk or without it. In case of replacement of a nave the second way as in spare parts the nave is delivered without disk is more preferable.

1. Slow down the car the parking brake, establish an emphasis under back wheels of the car. Lift and establish a forward part of the car on support, remove a wheel.
2. Remove a brake disk (see. "Replacement of a brake disk").
3. Turn out three screws of fastening of a cap of the coupling of shutdown of wheels …
4. … also remove it.
5. Holding a wheel nave from a provorachivaniye an assembly shovel, turn out six bolts of fastening of the coupling of shutdown of a wheel …
6. … also remove the coupling.
7. A chisel unbend a petal of a key washer …
8. … also turn off a nave lock-nut.
9. Having hooked the screw-driver, take a key washer.
10. Turn off a nave nut.
11. Remove a lock washer …
12. … and a nave assembled with bearings.

Good advice
In case of very strong landing of internal holders of hug bearings (the nave does not manage to be removed) use a stripper.

13. Attentively examine all details of a nave, estimate a condition of bearings on a pin (see. "Replacement of hug bearings of a forward wheel") and bolts of fastening of a wheel, if necessary replace bearings and bolts.
14. For replacement of a bolt of a nave record a nave in a vice and a vypressuyta bolts. Press a new bolt easy blows of the hammer to its head.
15. Establish details as it should be, the return to removal.
16. Adjust a gap in hug bearings (see. "Adjustment of a gap in bearings of naves of forward wheels").

Note
When latching nuts of hug bearings bend petals of a key washer on the verge of both nuts.