7.2.3. Removal and installation of a nave of a back wheel

Naves of back and forward wheels of the UAZ Hunter car are identical.
The brake drum and flange of a half shaft are attached to a nave of a back wheel.
It will be required to you: a special tubular key "on 55", the screw-driver with a flat edge, the hammer, a chisel.
1. Slow down the car, having established an emphasis under forward wheels of the car. Lift and establish a back part of the car on support.
2. Remove a half shaft (see. "Removal and installation of a half shaft").
3. Remove a wheel.

Good advice
In spite of the fact that the nave of a back wheel can be removed assembled with the brake drum, we recommend to remove the brake drum for reduction of weight of knot.

4. Unbend a petal of a key washer …
5. … also turn off a nave lock-nut.
6. Having hooked the screw-driver, take a key washer.
7. Turn off an adjusting nut.
8. Remove a lock washer …
9. … and a nave assembled with bearings.

Good advice
In case of dense landing of internal holders of hug bearings on a pin (the nave does not manage to be removed by effort of hands) use a stripper.

10. Attentively examine all details of a nave. Estimate a condition of bearings (see. "Replacement of hug bearings of a back wheel") and bolts of fastening of a wheel, if necessary replace defective parts.
11. For replacement of a bolt of a nave record a nave in a vice and a vypressuyta a bolt. Press a new bolt in a nave accurate blows of the hammer to its head.
12. Establish new details as it should be, the return to removal.
13. Adjust a gap in hug bearings (see. "Adjustment of a gap in bearings of naves of back wheels").

Note
When latching nuts of hug bearings bend petals of a key washer on the verge of a nut and a lock-nut.