8.3.1. Removal, dismantling and installation of a steering wheel
It will be required to you: a face head "on 24", the screw-driver with a crosswise edge.
|
|
1. Turn out three screws of fastening of an overlay of a steering wheel …
|
2. … also remove it.
|
3. Weaken an inhaling of a nut of fastening of a steering wheel.
Good advice
It is possible to record a steering wheel from a provorachivaniye by means of the locking mechanism of the anti-theft device of the lock of ignition. For this purpose take out a key from the lock of ignition and turn a steering wheel until fixing of a shaft the anti-theft device. After weakening of an inhaling of a nut of fastening of a steering wheel switch-off the anti-theft device, having inserted a key into the ignition lock, and again establish a steering wheel in provision of the rectilinear movement.
|
Prevention
Do not turn off a nut completely, otherwise at removal of a steering wheel it is possible to put with hands in case of its sharp detachment from a shaft to itself a trauma.
|
|
|
4. If you remove a steering wheel not for replacement, mark its provision of rather steering shaft.
|
5. Sharp blows of hands bring down a steering wheel from shliyets of a shaft.
|
Note
If it is not possible to bring down hands a steering wheel, screw in openings of a steering wheel two bolts with the established washers …
|
… also press a steering wheel a stripper.
|
|
6. Finally turn off a fastening nut …
|
7. … also remove a steering wheel.
|
|
|
8. Turn out three screws of fastening of the lower internal contact ring of the switch of a sound signal …
|
9. … also remove a ring.
|
|
|
10. Take a pin and a spring from a nave of a steering wheel.
|
11. Take away the holder of the lower contact rings from a nave of a steering wheel …
|
|
|
12. … also remove the holder, having disconnected from him wires.
|
13. Remove the lower overlay of a steering wheel.
|
14. If necessary remove switches of a sound signal, having disconnected from them wires and having turned out fastening screws.
15. Establish details as it should be, the return to removal.