9.11.1. Adjustment of the drive of the parking brake

At the correct adjustment of the parking brake the car has to slow down when raising the lever on 3–5 clicks.

Prevention
It is forbidden to check operation of the parking brake system at start-off from the place or at the movement. You carry out an inspection only on a bias.

You carry out adjustment of the drive of the parking brake when the working course of the lever becomes more than a half of a full speed (more than 7-8 clicks).
Increase in the course of the lever can be caused by two reasons:
– increase in a gap between a drum and blocks of the parking brake (in this case it is necessary to adjust a gap);
– a drive cable pulling (in this case it is necessary to adjust a cable tension).
It will be required to you: keys "on 11", "on 13", passatizh.
Adjustment of a gap between a drum and blocks of the parking brake is carried out in the following order.
1. Establish a control lever by the transfer case in neutral situation.
2. Move the lever of the drive of the parking brake to extreme lower situation.
3. You will hang out back wheels of the car.
4. Tighten the adjusting screw so that the drum of the parking brake could not be turned by effort of hands.
5. Turn out the adjusting screw on 1/3–1/2 turns (4–6 clicks) that the drum was freely rotated.
6. Adjust a tension of a cable of the drive of the parking brake (see below).

Adjustment of a tension of a cable of the drive of the parking brake is carried out or shift of a tip of a cable to the top situation on the drive lever, or change of length of draft of the drive of the parking brake.
For shift of a tip of a cable in the top situation on the lever of the drive execute the following.
1. Rasshplintuyte finger of fastening of a cable of the drive of the parking brake …
2. … take it from openings of the lever and a tip of a cable, combine the top opening of the lever and an opening of a tip of a cable, implant a finger and install the new forelock.

You carry out adjustment of a tension of a cable by change of length of draft of the drive in the following order.
1. Uncover the floor hatch (see. "Removal and installation of covers of the hatch of a floor").
2. Weaken a key a draft fork lock-nut inhaling.
3. Rasshplintuyte fork finger …
4. … also take it from openings of a fork and the lever of the drive.
5. Take away a fork from the lever and rotation of a fork adjust draft length.
6. Combine openings in a fork and the lever, establish a finger and its zashplintuyta.
7. Tighten a fork lock-nut.
8. Establish details as it should be, the return to removal.