9.4. Check and adjustment of a free wheeling of a pedal of a brake

Correctness of provision of a pedal of a brake and when pressing against the stop (the working course of a pedal) serves one of criteria for check of serviceability of the brake system in a free state. At the same time the provision of a pedal in many respects ensures correct functioning of system. If the pedal is from a floor at distance which is more standard, perhaps incomplete disinhibition of wheels at a pedal otpuskaniye (at the same time usually there is no free wheeling of a pedal). If the pedal is too low, the decrease in efficiency of brakes caused by reduction of the working course of a pedal is possible.
It will be required to you: a ruler, two keys "on 19".
1. Measure distance from an overlay of a pedal to a floor in a free state.
2. Press a hand a pedal until increase in resistance and measure distance from an overlay of a pedal to a floor in this situation. The difference between these two measurements will also be a free wheeling of a pedal which has to make 5–14 mm. If value of a free wheeling of a pedal does not keep within this interval, adjust it …
3. … rotation of an emphasis of the switch of stoplights in this or that party. If the emphasis did not succeeded to adjust a free wheeling …
4. … disconnect from the switch of a block of a plait of wires …
5. … weaken an inhaling of lock-nuts and adjust a free wheeling of a pedal of a brake the switch of stoplights.
6. Connect to the place of a block of a plait of wires.