9.5.1. Replacement of a tank of the main brake cylinder

You will need the screw-driver.
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Disconnect a block of a plait of wires from the sensor of level of brake fluid.
3. Turn off a stopper of a tank and pump out from it brake fluid, for example, the medical syringe or a rubber pear.
4. Having hooked the screw-driver, remove a tank, taking its branch pipes from connecting plugs (it is for descriptive reasons shown on the removed main brake cylinder).
5. Take connecting plugs from cylinder case openings (if necessary hook them the screw-driver). Examine plugs and if rubber aging signs appeared, replace them.
6. Install a tank of the main brake cylinder as it should be, the return to removal.

Good advice
For simplification of installation of a tank moisten connecting plugs with fresh brake fluid.

7. Fill in brake fluid and remove air from a hydraulic actuator (see. "Pumping of a hydraulic actuator of the brake system").