9.5.2. Replacement of the main brake cylinder

As practice shows, in many cases the cylinder partition in garage conditions does not result in desirable result. Therefore in case of malfunction we recommend to replace the main brake cylinder assembled.
It will be required to you: a key "on 17", a special key "on 12" for nuts of pipelines.
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Turn off a stopper of a tank of the main brake cylinder and pump out brake fluid from a tank, for example, the medical syringe. Establish into place a tank stopper that dirt did not get to it.

Note
The main brake cylinder can be removed as assembled with a tank, and without it. In this subsection removal of the brake cylinder assembled with a tank is described.

3. Turn off fastening nuts to the cylinder of two pipelines, having substituted capacity for collecting the following liquid, and take pipelines aside.

Good advice
Muffle pipelines in any available way (for example, having put on their ends protective caps of valves for production of air) to prevent an effluence of brake fluid.

4. Turn off two nuts of fastening...
5. … also remove the main brake cylinder assembled with a tank.
6. If necessary remove a tank from the main brake cylinder (see. "Replacement of a tank of the main brake cylinder").
7. Establish details as it should be, the return to removal, fill in brake fluid and remove air from a system hydraulic actuator (see. "Pumping of a hydraulic actuator of the brake system").